CLI Guide

• Priority group 2 contains traffic with dot1p priority 4.
• Priority group 4 contains traffic with dot1p priority 5, 6, and 7.
To remove a priority-pgid configuration from a DCB map, enter the no
priority-pgid command.
Related
Commands
priority-group bandwidth pfc— Configures the ETS bandwidth allocation and the
PFC setting used to manage the port traffic in an 802.1p priority group.
qos-policy-output ets
To configure the ETS bandwidth allocation and scheduling for priority traffic, create a QoS output policy.
Syntax
qos-policy-output policy-name ets
To remove the QoS output policy, use the no qos-policy-output ets
command.
Parameters
policy-name Enter the policy name. The maximum is 32 characters.
Command Modes CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
If an error occurs in an ETS output-policy configuration, the configuration is
ignored and the scheduler and bandwidth allocation settings are reset to the ETS
default values (all priorities are in the same ETS priority group and bandwidth is
allocated equally to each priority).
If an error occurs when a port receives a peer’s ETS configuration, the port’s
configuration is reset to the previously configured ETS output policy. If no ETS
output policy was previously applied, the port is reset to the default ETS
parameters.
Related
Commands
• scheduler — schedules the priority traffic in port queues.
490
Data Center Bridging (DCB)