CLI Guide

To remove the configured iSCSI priority, use the no iscsi priority-bits

command.

Parameters

priority-bitmap Enter the priority-bitmap range. The range is from 1 to FF.

Defaults 0x10

Command Modes PROTOCOL LLDP

Supported Modes Programmable-Mux (PMUX)

Full–Switch

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

9.4(0.0) Supported on the FN I/O Aggregator.

9.3(0.0) Introduced on the FC Flex IO module installed in the M I/O

Aggregator.

Usage Information This command is available at the global level only.

keepalive

Send keepalive packets periodically to keep an interface alive when it is not transmitting data.

Syntax

keepalive [seconds]

To stop sending keepalive packets, use the no keepalive command.

Parameters

seconds (OPTIONAL) For interfaces with PPP encapsulation enabled,

enter the number of seconds between keepalive packets.

The range is from 0 to 23767. The default is 10 seconds.

Defaults Enabled.

Command Modes INTERFACE