CLI Guide

unmounting / (/dev/md0a)... done
rebooting...
Dell#show dcb stack-unit 0 port-set 0
stack-unit 0 port-set 0
DCB Status: Enabled, PFC Queue Count: 4
stack-unit Total Buffer PFC Total Buffer PFC Shared Buffer PFC Available Buffer
PP (KB) (KB) (KB) (KB)
----------------------------------------------------------------
0 0 3822 1912 832 450
Dell(conf)#
dcb-map stack-unit all stack-ports all
Apply the specified DCB map on all ports of the switch stack.
Syntax
dcb-map stack-unit all stack-ports all dcb-map-name
To remove the PFC and ETS settings in a DCB map from all stack units, use the no
dcb-map stack-unit all stack-ports all command.
Parameters
dcb-map-name Enter the name of the DCB map.
Defaults None
Command Modes CONFIGURATION
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.3(0.0) Introduced on the FC Flex IO Modules with I/O Aggregator.
Usage Information The dcb-map stack-unit all stack-ports all command overwrites any
previous DCB maps applied to stack ports.
dcbx-port role
Configure the DCBX port role the interface uses to exchange DCB information.
Syntax
dcbx port-role {config-source | auto-downstream | auto-upstream
| manual}
To remove DCBX port role, use the no dcbx port-role {config-source |
auto-downstream | auto-upstream | manual} command.
Data Center Bridging (DCB)
475