CLI Guide

Defaults All PFC and ETS TLVs are advertised.
Command Modes PROTOCOL LLDP
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
You can configure the transmission of more than one TLV type at a time; for
example: advertise dcbx-tlv ets-conf ets-reco.
You can enable ETS recommend TLVs (ets-reco) only if you enable ETS
configuration TLVs (
ets-conf). To disable TLV transmission, use the no form of
the command; for example,
no advertise dcbx-tlv pfc ets-reco.
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Configure DCBX operation at the INTERFACE level on a switch or globally on the
switch. To verify the DCBX configuration on a port, use the show interface
dcbx detail command.
bandwidth-percentage
Assign a percentage of weight to the class/queue.
Syntax
bandwidth-percentage percentage
To remove the bandwidth percentage, use the no bandwidth-percentage
command.
Parameters
percentage Enter the percentage assignment of weight to the class/
queue. The range is from 1 to 100% (granularity 1%).
Defaults none
Command Modes CONFIGURATION (conf-qos-policy-out)
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Data Center Bridging (DCB)
467