CLI Guide

NOTE: When you reconfigure CAM allocation, use the
nlbclusteracl number command to change the
number of NLB ARP entries. The range is from 0 to 2.
The default value is 0. At the default value of 0, eight
NLB ARP entries are available for use. This platform
supports upto 256 CAM entries. Select 1 to configure
128 entries. Select 2 to configure 256 entries. Even
though you can perform CAM carving to allocate the
maximum number of NLB entries, Dell Networking
recommends that you use a maximum of 64 NLB ARP
entries.
Vman-qos|vman-
dual-qos number
Enter the keyword evman-qos and then the number of FP
blocks for VMAN QoS. The range is from 0 to 6.
vman-dual-qos
number
Enter the keyword vman-dual-qos and then the number of
FP blocks for VMAN dual QoS. The range is from 0 to 4.
Ipv4pbr number Enter the keyword ipv4pbr and then the number of FP
blocks for ipv4pbr ACL. The range is from 0 to 8.
Openflow number Enter the keyword openflow and then the number of FP
blocks for open flow (multiples of 4). The range is from 0 to
8.
fcoeacl number Enter the keyword fcoeacl and then the number of FP
blocks for FCOE ACL. The range is from 0 to 6.
Iscsioptacl
number
Enter the keyword iscsioptacl and then the number of
FP blocks for iSCSI optimization ACL. The range is from 0 to
2.
l2acl number
ipv4acl number
ipv6acl number,
ipv4qos number
l2qos number,
l2pt number
ipmacacl number
ecfmacl number
[vman-qos |
vman--qos-dual
number | vman-
qos-dual-fp
number] ipv4pbr
number
Allocate space to each CAM region.
Enter the CAM profile name then the amount of CAM space
to be allotted. The total space allocated must equal 13. The
range for ipv4acl is from 1 to 4. The ipv6acl range must be a
factor of 2.
The total space allocated must equal 13.
The range for ipv4acl is 1 to 4.
The ipv6acl range must be a factor of 2.
The vman-qos-dual-fp number must be entered as a
multiple of 4.
Command Modes CONFIGURATION
Supported Modes Full–Switch
444
Content Addressable Memory (CAM)