CLI Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
timers bgp
Adjust the BGP Keep Alive and Hold Time timers.
Syntax
timers bgp keepalive holdtime
To return to the default, use the no timers bgp command.
Parameters
keepalive Enter a number for the time interval, in seconds, between
keepalive messages sent to the neighbor routers. The range
is from 1 to 65535. The default is 60 seconds.
holdtime Enter a number for the time interval, in seconds, between
the last keepalive message and declaring the router dead.
The range is from 3 to 65535. The default is 180 seconds.
Defaults none
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
MBGP Commands
Multiprotocol BGP (MBGP) is an enhanced BGP that enables multicast routing policy throughout the
internet and connecting multicast topologies between BGP and autonomous systems (ASs).
MBGP is implemented as per IETF RFC 1858.
428
Border Gateway Protocol IPv4 (BGPv4)