CLI Guide

• ^ = (caret) the beginning of the input string. If you use
the caret at the beginning of a sequence or range, it
matches on everything BUT the characters specified.
• $ = (dollar sign) the end of the output string.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
The following describes the show ip bgp regexp command shown in the
following example.
Field Description
Network Displays the destination network prefix of each BGP route.
Next Hop Displays the next hop address of the BGP router. If 0.0.0.0 is
listed in this column, then non-BGP routes exist in the
router’s routing table.
Metric Displays the BGP router’s metric, if assigned.
LocPrf Displays the BGP LOCAL_PREF attribute for the route.
Weight Displays the route’s weight
Path Lists all the AS paths the route passed through to reach the
destination network.
Example (S4810)
Dell#show ip bgp regexp ^2914+
BGP table version is 3700481, local router ID is 63.114.8.35
Status codes: s suppressed, S stale, d damped, h history, *
valid, > best
Path source: I - internal, a - aggregate, c - confed-external,
r - redistributed, n - network
Origin codes: i - IGP, e - EGP, ? - incomplete
Network Next Hop Metric LocPrf Weight Path
*>I 3.0.0.0/8 1.1.1.2 0 100 0 2914 1239 80
i
*>I 4.0.0.0/8 1.1.1.2 0 100 0 2914 3356 i
*>I 4.17.225.0/24 1.1.1.2 0 100 0 2914 11853
11853 11853 11853 11853 6496
*>I 4.17.226.0/23 1.1.1.2 0 100 0 2914 11853
11853 11853 11853 11853 6496
*>I 4.17.251.0/24 1.1.1.2 0 100 0 2914 11853
11853 11853 11853 11853 6496
*>I 4.17.252.0/23 1.1.1.2 0 100 0 2914 11853
11853 11853 11853 11853 6496
*>I 4.19.2.0/23 1.1.1.2 0 100 0 2914 701
424
Border Gateway Protocol IPv4 (BGPv4)