CLI Guide

no-export
Enter the keywords no-export to view all routes
containing the well-known community attribute of
NO_EXPORT.
All routes with the NO_EXPORT (0xFFFFFF01) community
attribute must not be advertised outside a BGP
confederation boundary.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
To view the total number of COMMUNITY attributes found, use the show ip bgp
summary command. The text line above the route table states the number of
COMMUNITY attributes found.
The show ip bgp community command without any parameters lists BGP
routes with at least one BGP community attribute and the output is the same as for
the
show ip bgp command output.
The following describes the show ip bgp community command shown in the
following example.
Field Description
Network Displays the destination network prefix of each BGP route.
Next Hop Displays the next hop address of the BGP router. If 0.0.0.0 is
listed in this column, then local routes exist in the routing
table.
Metric Displays the BGP route’s metric, if assigned.
LocPrf Displays the BGP LOCAL_PREF attribute for the route.
Weight Displays the route’s weight.
Path Lists all the ASs the route passed through to reach the
destination network.
Example
Dell>show ip bgp community
BGP table version is 3762622, local router ID is 63.114.8.48
Status codes: s suppressed, d damped, h history, * valid, >
best
Path source: I - internal, a - aggregate, c - confed-external,
Border Gateway Protocol IPv4 (BGPv4)
401