CLI Guide

Parameters
ip-address Enter the IP address of the neighbor in dotted decimal
format.
peer-group-name Enter the name of the peer group to disable or enable all
routers within the peer group.
Defaults Enabled (that is, BGP neighbors and peer groups are disabled.)
Command Modes ROUTER BGP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
Peers that are enabled within a peer group are disabled when their peer group is
disabled.
The neighbor shutdown command terminates all BGP sessions on the BGP
neighbor or BGP peer group. Use this command with caution as it terminates the
specified BGP sessions. When a neighbor or peer group is shut down, use the
show
ip bgp summary command to confirm its status.
Related
Commands
show ip bgp summary — displays the current BGP configuration.
show ip bgp neighbors — displays the current BGP neighbors.
neighbor soft-reconfiguration inbound
Enable soft-reconfiguration for BGP.
Syntax
neighbor {ip-address | peer-group-name} soft-reconfiguration
inbound
To disable, use the no neighbor {ip-address | peer-group-name} soft-
reconfiguration inbound command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal
format.
peer-group-name Enter the name of the peer group to disable or enable all
routers within the peer group.
Defaults Disabled
Border Gateway Protocol IPv4 (BGPv4)
387