CLI Guide

neighbor default-originate
Inject the default route to a BGP peer or neighbor.
Syntax
neighbor {ip-address | peer-group-name} default-originate
[route-map map-name]
To remove a default route, use the no neighbor {ip-address | peer-
group-name} default-originate command.
Parameters
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
peer-group-name Enter the name of the peer group to set the default route of
all routers in that peer group.
route-map map-
name
(OPTIONAL) Enter the keyword route-map then the name
of a configured route map.
Defaults Not configured.
Command Modes ROUTER BGP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information If you apply a route map to a BGP peer or neighbor with the neighbor default-
originate command configured, the software does not apply the set filters in the
route map to that BGP peer or neighbor.
neighbor description
Assign a character string describing the neighbor or group of neighbors (peer group).
Syntax
neighbor {ip-address | peer-group-name} description text
To delete a description, use the no neighbor {ip-address | peer-group-
name} description command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal
format.
peer-group-name Enter the name of the peer group.
text Enter a continuous text string up to 80 characters.
Border Gateway Protocol IPv4 (BGPv4)
373