CLI Guide

To disable debugging, use the no debug ip bgp [ip-address | peer-group
peer-group-name] keepalives [in | out] command.
Parameters
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
peer-group peer-
group-name
(OPTIONAL) Enter the keyword peer-group then the name
of the peer group.
in (OPTIONAL) Enter the keyword in to view only inbound
keepalive messages.
out (OPTIONAL) Enter the keyword out to view only outbound
keepalive messages.
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
To remove all configured debug commands for BGP, enter the no debug ip bgp
command.
debug ip bgp notifications
Allows you to view information about BGP notifications received from neighbors.
Syntax
debug ip bgp [ip-address | peer-group peer-group-name]
notifications [in | out]
To disable debugging, use the no debug ip bgp [ip-address | peer-group
peer-group-name] notifications [in | out] command.
Parameters
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
peer-group peer-
group-name
(OPTIONAL) Enter the keyword peer-group then the name
of the peer group.
in (OPTIONAL) Enter the keyword in to view BGP notifications
received from neighbors.
out (OPTIONAL) Enter the keyword out to view BGP
notifications sent to neighbors
Border Gateway Protocol IPv4 (BGPv4)
365