CLI Guide

both Enter the keyword both to indicate that the system sends
and accepts multiple paths from peers.
path-count Enter the number paths supported. The range is from 2 to
64.
Defaults Disabled
Command Modes
• ROUTER BGP
• ROUTER BGP-address-family
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
neighbor add-path — specifies that this neighbor/peer group can send/receive
multiple path advertisements.
bgp always-compare-med
Allows you to enable comparison of the MULTI_EXIT_DISC (MED) attributes in the paths from different
external ASs.
Syntax
bgp always-compare-med
To disable comparison of MED, enter no bgp always-compare-med.
Defaults Disabled (that is, the software only compares MEDs from neighbors within the
same AS).
Command Modes ROUTER BGP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
Any update without a MED attribute is the least preferred route.
If you enable this command, use the clear ip bgp * command to recompute
the best path.
342
Border Gateway Protocol IPv4 (BGPv4)