CLI Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.3(0.0) Introduced on the MXL platform.
Usage Information The VLAN ContentAware Processor (VCAP) application is a pre-ingress CAP that
modifies the VLAN settings before packets are forwarded. To support the ACL CAM
optimization functionality, the CAM carving feature is enhanced. A total of four
VACP groups are present, of which two are for fixed groups and the other two are
for dynamic groups. Out of the total of two dynamic groups, you can allocate zero,
one, or two flow processor (FP) blocks to iSCSI Counters, OpenFlow and ACL
Optimization. You can configure only two of these features at a point in time.
show cam-usage
View the amount of CAM space available, used, and remaining in each partition (including IPv4Flow and
Layer 2 ACL sub-partitions).
Syntax
show cam-usage [acl | router | switch]
Parameters
acl
(OPTIONAL) Enter the keyword acl to display Layer 2 and
Layer 3 ACL CAM usage.
router
(OPTIONAL) Enter the keyword router to display Layer 3
CAM usage.
switch
(OPTIONAL) Enter the keyword switch to display Layer 2
CAM usage.
Command Modes
EXEC
EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.3(0.0) Introduced on the MXL 10/40GbE Switch IO Module
platform.
Usage Information The following regions must be provided in the show cam-usage output:
• L3AclCam
Access Control List (ACL) VLAN Groups and Content Addressable Memory (CAM)
321