CLI Guide

any Enter the keyword any to match and drop any ARP traffic
on the interface.
vlan vlan-id
Enter the keyword vlan followed by the VLAN ID to filter
traffic associated with a specific VLAN. The range is 1 to
4094 and 1 to 2094 for ExaScale (you can use IDs 1 to
4094). To filter all VLAN traffic specify VLAN 1.
ip-address Enter an IP address in dotted decimal format (A.B.C.D) as the
target IP address of the ARP.
opcode code-
number
Enter the keyword opcode and then enter the number of
the ARP opcode. The range is 1 to 16.
count (OPTIONAL) Enter the keyword count to count packets the
filter processes.
byte (OPTIONAL) Enter the keyword byte to count bytes the
filter processes.
order (OPTIONAL) Enter the keyword order to specify the QoS
priority for the ACL entry. The range is 0 to 254 (where 0 is
the highest priority and 254 is the lowest; lower-order
numbers have a higher priority). If you do not use the
keyword order, the ACLs have the lowest order by default
(255).
log (OPTIONAL) Enter the keyword log to enable the triggering
of ACL log messages.
interval minutes (OPTIONAL) Enter the keyword interval followed by the
time period in minutes at which ACL logs must be
generated. The interval range is from 1 to 10 minutes.
threshold-in msgs
count
(OPTIONAL) Enter the threshold-in-msgs keyword
followed by a value to indicate the maximum number of
ACL logs that can be generated, exceeding which the
generation of ACL logs is terminated with the seq, permit,
or
deny commands. The threshold range is from 1 to 100.
monitor (OPTIONAL) Enter the keyword monitor when the rule is
describing the traffic that you want to monitor and the ACL
in which you are creating the rule is applied to the
monitored interface.
NOTE: For more information, refer to the Flow-based
Monitoring section in the Port Monitoring chapter of the
Dell Networking OS Configuration Guide.
Defaults
By default, 10 ACL logs are generated if you do not specify the threshold explicitly.
The default frequency at which ACL logs are generated is five minutes. By default,
flow-based monitoring is not enabled.
Access Control Lists (ACL)
285