CLI Guide

For the MAC address mask, specify which bits in the MAC
address must match.
The MAC ACL supports an inverse mask; therefore, a mask
of ff:ff:ff:ff:ff:ff allows entries that do not match and a mask
of 00:00:00:00:00:00 only allows entries that match
exactly.
any Enter the keyword any to match and drop specific Ethernet
traffic on the interface.
vlan vlan-id Enter the keyword vlan and then enter the VLAN ID to filter
traffic associated with a specific VLAN. The range is 1 to
4094 and 1 to 2094 for ExaScale ( you can use IDs 1 to
4094). To filter all VLAN traffic, specify VLAN 1.
source-mac-
address mac-
address-mask
Enter a MAC address and mask in the nn:nn:nn:nn:nn
format.
For the MAC address mask, specify which bits in the MAC
address must match.
The MAC ACL supports an inverse mask; therefore, a mask
of ff:ff:ff:ff:ff:ff allows entries that do not match and a mask
of 00:00:00:00:00:00 only allows entries that match
exactly.
count (OPTIONAL) Enter the keyword count to count packets
processed by the filter.
byte (OPTIONAL) Enter the keyword byte to count bytes
processed by the filter.
order (OPTIONAL) Enter the keyword order to specify the QoS
priority for the ACL entry. The range is from 0 to 254 (where
0 is the highest priority and 254 is the lowest; lower order
numbers have a higher priority) If you did not use the
keyword order, the ACLs have the lowest order by default
(255).
log (OPTIONAL) Enter the keyword log to enable the triggering
of ACL log messages.
threshold-in msgs
count
(OPTIONAL) Enter the threshold-in-msgs keyword
followed by a value to indicate the maximum number of
ACL logs that can be generated, exceeding which the
generation of ACL logs is terminated with the seq, permit,
or
deny commands. The threshold range is from 1 to 100.
interval minutes (OPTIONAL) Enter the keyword interval followed by the
time period in minutes at which ACL logs must be
generated. The time interval range is from of 1 to 10
minutes.
256
Access Control Lists (ACL)