CLI Guide

set tag
To specify a tag for redistributed routes, configure a filter.
Syntax
set tag tag-value
Parameters
tag-value Enter a number as the tag. The range is from zero (0) to
4294967295.
Defaults Not configured.
Command Modes ROUTE-MAP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
set automatic-tag — computes the tag value of the route.
set metric — specifies the metric value assigned to redistributed routes.
set metric-type — specifies the route type assigned to redistributed routes.
show config
Display the current route map configuration.
Syntax
show config
Command Modes ROUTE-MAP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Example
Dell(config-route-map)#show config
!
route-map hopper permit 10
Dell(config-route-map)#
236
Access Control Lists (ACL)