CLI Guide

match ip route-source
To match based on the routes advertised by routes specified in IP access lists or IP prefix lists, configure a
filter.
Syntax
match ip route-source {access-list | prefix-list prefix-list-
name}
Parameters
access-list-name Enter the name of a configured IP access list, up to 140
characters.
prefix-list prefix-
list-name
Enter the keywords prefix-list and then enter the name
of configured prefix list, up to 140 characters.
Defaults Not configured.
Command Modes ROUTE-MAP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
match interface — redistributes routes that match the next-hop interface.
match ip address — redistributes routes that match an IP address.
match ip next-hop — redistributes routes that match the next-hop IP address.
match metric — redistributes routes that match a specific metric.
match route-type — redistributes routes that match a route type.
match tag — redistributes routes that match a specific tag.
match metric
To match on a specified value, configure a filter.
Syntax
match metric metric-value
Parameters
metric-value Enter a value to match. The range is from zero (0) to
4294967295.
Defaults Not configured.
Command Modes ROUTE-MAP
230
Access Control Lists (ACL)