CLI Guide

description
Add a description to this route map.
Syntax
description description
Parameters
description Enter a description to identify the route map (80 characters
maximum).
Defaults none
Command Modes ROUTE-MAP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
route-map — Enables a route map.
match interface
To match routes whose next hop is on the interface specified, configure a filter.
Syntax
match interface interface
To remove a match, use the no match interface interface command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For the Loopback interface, enter the keyword
loopback then a number from zero (0) to 16383.
• For a Port Channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
• For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
Defaults Not configured.
Command Modes ROUTE-MAP
Supported Modes Full–Switch
Access Control Lists (ACL)
227