CLI Guide

show ip prefix-list summary
Display a summary of the configured prefix lists.
Syntax
show ip prefix-list summary [prefix-name]
Parameters
prefix-name (OPTIONAL) Enter a text string as the name of the prefix list,
up to 140 characters.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell#show ip prefix-list summary
Ip Prefix-list with the last deletion/insertion: PL_OSPF_to_RIP
ip prefix-list PL_OSPF_to_RIP:
count: 3, range entries: 1, sequences: 5 - 25
Route Map Commands
When you create an access-list without any rule and then applied to an interface, the ACL behavior
reflects implicit permit.
To configure route maps and their redistribution criteria, use the following commands.
continue
To a route-map entry with a higher sequence number, configure a route-map.
Syntax
continue [sequence-number]
Parameters
sequence-
number
(OPTIONAL) Enter the route map sequence number. The
range is from 1 to 65535. The default is: no sequence
number
Defaults Not configured
Command Modes ROUTE-MAP
Access Control Lists (ACL)
225