CLI Guide

seq
To a deny or permit filter in a prefix list while configuring the filter, assign a sequence number.
Syntax
seq sequence-number {deny | permit} {any} | [ip-prefix /nn {ge
min-prefix-length} {le max-prefix-length}] | [bitmask number]
Parameters
sequence-
number
Enter a number. The range is from 1 to 4294967294.
deny Enter the keyword deny to configure a filter to drop packets
meeting this condition..
permit Enter the keyword permit to configure a filter to forward
packets meeting this condition.
any (OPTIONAL) Enter the keyword any to match any packets.
ip-prefix /nn (OPTIONAL) Specify an IP prefix in the network/length
format. For example, 35.0.0.0/8 means match the first 8 bits
of address 35.0.0.0.
ge min-prefix-
length
(OPTIONAL) Enter the keyword ge and then enter the
minimum prefix length, which is a number from zero (0) to
32.
le max-prefix-
length
(OPTIONAL) Enter the keyword le and then enter the
maximum prefix length, which is a number from zero (0) to
32.
bitmask number Enter the keyword bitmask then enter a bit mask number
in dotted decimal format.
Defaults Not configured.
Command Modes PREFIX-LIST
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
If you do not use the ge or le options, only packets with an exact match to the
prefix are filtered.
Related
Commands
deny — configures a filter to drop packets.
permit — configures a filter to pass packets.
Access Control Lists (ACL)
223