CLI Guide

of 00:00:00:00:00:00 only allows entries that match
exactly.
ethertype
operator
(OPTIONAL) To filter based on protocol type, enter one of
the following Ethertypes:
• ev2 - is the Ethernet II frame format
• llc - is the IEEE 802.3 frame format
• snap - is the IEEE 802.3 SNAP frame format
count (OPTIONAL) Enter the keyword count to count packets the
filter processes.
byte (OPTIONAL) Enter the keyword byte to count bytes the
filter processes.
Defaults Not configured.
Command Modes CONFIGURATION-MAC ACCESS LIST-EXTENDED
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
deny — configures a MAC ACL filter to drop packets.
seq — configure a MAC ACL filter with a specified sequence number.
seq
Configure a filter with a specific sequence number.
Syntax
seq sequence-number {deny | permit} {any | host mac-address |
mac-source-address mac-source-address-mask} {any | host mac-
address | mac-destination-address mac-destination-address-mask}
[ethertype operator] [count [byte]]
Parameters
sequence-
number
Enter a number as the filter sequence number. The range is
from zero (0) to 65535.
deny Enter the keyword deny to drop any traffic matching this
filter.
permit Enter the keyword permit to forward any traffic matching
this filter.
218
Access Control Lists (ACL)