CLI Guide

bytes
Dell(config-ext-macl)#remark 15 ARP
Dell(config-ext-macl)#seq 20 permit any any ev2 eq 806 count
bytes
Dell(config-ext-macl)#remark 25 IPv6
Dell(config-ext-macl)#seq 30 permit any any ev2 eq 86dd count
bytes
Dell(config-ext-macl)#seq 40 permit any any count bytes
Dell(config-ext-macl)#exit
Dell(conf)#do show mac accounting access-list snickers
interface g0/47 in
Extended mac access-list snickers on TenGigabitEthernet 0/12
seq 10 permit any any ev2 eq 800 count bytes (559851886
packets 191402152148bytes)seq 20 permit any any ev2 eq 806
count bytes
(74481486 packets 5031686754bytes)seq 30 permit any any ev2 eq
86dd count bytes (7751519 packets 797843521 bytes)
Related
Commands
mac access-list standard — configures a standard MAC access list.
show mac accounting access-list — displays MAC access list configurations and
counters (if configured).
permit
To forward packets from a specific source MAC address, configure a filter.
Syntax
permit {any | mac-source-address [mac-source-address-mask]}
[count [byte]] | log [interval minutes] [threshold-in-
msgs[count] [monitor]
To remove this filter, you have two choices:
• Use the no seq sequence-number command if you know the filter’s
sequence number.
• Use the no permit {any | mac-source-address mac-source-
address-mask} command.
Parameters
any Enter the keyword any to forward all packets received with
a MAC address.
mac-source-
address
Enter a MAC address in nn:nn:nn:nn:nn:nn format.
mac-source-
address-mask
(OPTIONAL) Specify which bits in the MAC address must
match. If no mask is specified, a mask of 00:00:00:00:00:00
is applied (in other words, the filter allows only MAC
addresses that match).
count (OPTIONAL) Enter the keyword count to count packets
processed by the filter.
212
Access Control Lists (ACL)