CLI Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.3(0.0) Added the support for logging of ACLs on the MXL
10/40GbE Switch IO Module platform.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
The order option is relevant in the context of the Policy QoS feature only. For
more information, refer to the Quality of Service chapter of the Dell Networking OS
Configuration Guide.
You can configure either count (packets) or count (bytes). However, for an ACL
with multiple rules, you can configure some ACLs with count (packets) and others
as count (bytes) at any given time.
Most ACL rules require one entry in the CAM. However, rules with TCP and UDP
port operators (for example, gt, lt or range) may require more than one entry. The
range of ports is configured in the CAM based on bit mask boundaries; the space
required depends on exactly what ports are included in the range.
When the configured maximum threshold is exceeded, generation of logs is
stopped. When the interval at which ACL logs are configured to be recorded
expires, the subsequent, fresh interval timer is started and the packet count for that
new interval commences from zero. If ACL logging was stopped previously
because the configured threshold is exceeded, it is re-enabled for this new interval.
If ACL logging is stopped because the configured threshold is exceeded, it is re-
enabled after the logging interval period elapses. ACL logging is supported for
standard and extended IPv4 ACLs, IPv6 ACLs, and MAC ACLs. You can configure
ACL logging only on ACLs that are applied to ingress interfaces; you cannot enable
logging for ACLs that are associated with egress interfaces
Example
An ACL rule with a TCP port range of 4000–8000 uses eight entries in the CAM.
Dell# Data Mask From To #Covered
1 0000111110100000 1111111111100000 4000 4031 32
2 0000111111000000 1111111111000000 4032 4095 64
3 0001000000000000 1111100000000000 4096 6143 2048
4 0001100000000000 1111110000000000 6144 7167 1024
5 0001110000000000 1111111000000000 7168 7679 512
6 0001111000000000 1111111100000000 7680 7935 256
7 0001111100000000 1111111111000000 7936 7999 64
8 0001111101000000 1111111111111111 8000 8000 1
Total Ports: 4001
Example
An ACL rule with a TCP port lt 1023 uses only one entry in the CAM.
Dell# Data Mask From To #Covered
1 0000000000000000 1111110000000000 0 1023 1024
188
Access Control Lists (ACL)