CLI Guide

deny icmp
To drop all or specific internet control message protocol (ICMP) messages, configure a filter.
Syntax
deny icmp {source mask | any | host ip-address} {destination
mask | any | host ip-address} [dscp] [count [byte]] [order]
[fragments][threshold-in-msgs] [count]]
To remove this filter, you have two choices:
• Use the no seq sequence-number command, if you know the filter’s
sequence number.
• Use the no deny icmp {source mask | any | host ip-address}
{destination mask | any | host ip-address} command.
Parameters
source Enter the IP address of the network or host from which the
packets were sent.
mask Enter a network mask in /prefix format (/x) or A.B.C.D. The
mask, when specified in A.B.C.D format, may be either
contiguous or non-contiguous.
any Enter the keyword any to specify that all routes are subject
to the filter.
host ip-address Enter the keyword host then the IP address to specify a
host IP address.
destination Enter the IP address of the network or host to which the
packets are sent.
dscp Enter this keyword dscp to deny a packet based on the
DSCP value. The range is from 0 to 63.
count (OPTIONAL) Enter the keyword count to count packets
processed by the filter.
byte (OPTIONAL) Enter the keyword byte to count bytes
processed by the filter.
order (OPTIONAL) Enter the keyword order to specify the QoS
priority for the ACL entry. The range is from 0 to 254 (where
0 is the highest priority and 254 is the lowest; lower order
numbers have a higher priority) If you did not use the
keyword order, the ACLs have the lowest order by default
(255).
fragments Enter the keyword fragments to use ACLs to control
packet fragments.
threshold-in msgs
count
(OPTIONAL) Enter the threshold-in-msgs keyword
followed by a value to indicate the maximum number of
ACL logs that can be generated, exceeding which the
generation of ACL logs is terminated with the seq, permit,
or
deny commands. The threshold range is from 1 to 100.
Access Control Lists (ACL)
181