CLI Guide

ip access-list standard
Create a standard IP access list (IP ACL) to filter based on IP address.
Syntax
ip access-list standard access-list-name
Parameters
access-list-name Enter a string up to 140 characters long as the ACL name.
Defaults All IP access lists contain an implicit deny any, that is, if no match occurs, the
packet is dropped.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
The Dell operating system supports one ingress and one egress IP ACL per
interface.
The number of entries allowed per ACL is hardware-dependent. For detailed
specifications on entries allowed per ACL, refer to your line card documentation.
Example
Dell(conf)#ip access-list standard TestList
Dell(config-std-nacl)#
Related
Commands
ip access-list extended — creates an extended access list.
resequence access-list — Displays the current configuration.
permit (for Standard IP ACLs)
To permit packets from a specific source IP address to leave the switch, configure a filter.
Syntax
permit {source [mask]| any | host ip-address} [no-drop] [count
[byte]] [dscp value] [order] [fragments] [log [interval
minutes] [threshold-in-msgs [count]] [monitor]
To remove this filter, you have two choices:
• Use the no seq sequence-number command if you know the filter’s
sequence number.
• Use the no permit {source [mask] | any | host ip-address}
command.
Access Control Lists (ACL)
173