CLI Guide

resequence prefix-list ipv4
Re-assign sequence numbers to entries of an existing prefix list.
Syntax
resequence prefix-list ipv4 {prefix-list-name StartingSeqNum
Step-to-increment}
Parameters
prefix-list-name Enter the name of the configured prefix list, up to 140
characters long.
StartingSeqNum Enter the starting sequence number to resequence. The
range is from 0 to 65535.
Step-to-
Increment
Enter the step to increment the sequence number. The
range is from 1 to 65535.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
When you have exhausted all the sequence numbers, this feature permits re-
assigning a new sequence number to entries of an existing prefix list.
Related
Commands
seq — Assigns a sequence number to a deny or permit filter in an IP access list
while creating the filter.
show config
Display the current ACL configuration.
Syntax
show config
Command Modes
• CONFIGURATION-IP ACCESS-LIST-STANDARD
• CONFIGURATION-IP ACCESS-LIST-EXTENDED
• CONFIGURATION-MAC ACCESS LIST-STANDARD
• CONFIGURATION-MAC ACCESS LIST-EXTENDED
Supported Modes Full–Switch
Access Control Lists (ACL)
167