CLI Guide

show dot1x interface
Display the 802.1X configuration of an interface.
Syntax
show dot1x interface interface [mac-address mac-address]
Parameters
interface Enter one of the following keywords and slot/port or
number information:
• For a Ten-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
mac-address (Optional) MAC address of a supplicant.
Defaults none
Command Modes
• EXEC
• EXEC privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
If you enable 802.1X multi-supplicant authentication on a port, additional 802.1X
configuration details (Port Authentication status, Untagged VLAN ID, Authentication
PAE state, and Backend state) are displayed for each supplicant, as shown in the
following example.
Example
Dell#show dot1x interface tengigabitethernet 0/1
802.1x information on Te 0/1:
-----------------------------
Dot1x Status: Enable
Port Control: AUTO
Port Auth Status: AUTHORIZED(MAC-AUTH-BYPASS)
Re-Authentication: Disable
Untagged VLAN id: 400
Guest VLAN: Enable
Guest VLAN id: 100
Auth-Fail VLAN: Disable
Auth-Fail VLAN id: NONE
Auth-Fail Max-Attempts: NONE
Mac-Auth-Bypass: Enable
Mac-Auth-Bypass Only: Enable
Tx Period: 3 seconds
Quiet Period: 60 seconds
ReAuth Max: 2
Supplicant Timeout: 30 seconds
Server Timeout: 30 seconds
Re-Auth Interval: 3600 seconds
Max-EAP-Req: 2
162
802.1X