CLI Guide

Usage Information
To delete the FIP keepalive time period from an FCoE map, enter the no fka-
adv-erpiod command.
Related
Commands
fcoe-map — creates an FCoE map which contains the parameters used in the
communication between servers and a SAN fabric.
show fcoe-map — displays the Fibre Channel and FCoE configuration parameters
in FCoE maps.
interface vlan (NPIV proxy gateway)
Create a dedicated VLAN to be used to send and receive Fibre Channel traffic over FCoE links between
servers and a fabric over a switch with the FC Flex IO module NPIV proxy gateway.
Syntax
interface vlan vlan-id
Parameters
vlan-id Enter a number as the VLAN Identifier. The range is 1 to
4094.
Defaults Not configured.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.3.0.0 Introduced on the M I/O Aggregator and MXL 10/40GbE
Switch with the FC Flex IO module configured as an NPIV
proxy gateway.
Usage Information
FCoE storage traffic received from servers on a switch with the FC Flex IO module
NPIV proxy gateway is de-capsulated into Fibre Channel packets and forwarded
over FC links to SAN switches in a specified fabric. You must configure a separate
FCoE VLAN for each fabric to which FCoE traffic is forwarded. Any non-FCoE traffic
sent on a dedicated FCoE VLAN will be dropped.
You configure the association between a dedicated VLAN, which carries FCoE
traffic from server CNAs over the NPIV proxy gateway to a SAN fabric in which
destination storage arrays are installed, in an FCoE map by using the fabric id
vlan command.
When you apply an FCoE map to a server-facing Ethernet port, the port is
automatically configured as a tagged member of the FCoE VLAN.
For more information about VLANs and the commands to configure them, refer to
the Virtual LAN (VLAN) Commands section of the Layer 2 chapter.
1566
FC Flex IO Modules