CLI Guide

ManualsBrandsDell ManualsAccess PlatformsFN IO Module

1561

Command Modes FCOE MAP

Supported Modes Full–Switch

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

9.3(0.0) Introduced on the M I/O Aggregator and MXL 10/40GbE

Switch with the FC Flex IO module.

Usage Information

In the fabric-id vlan command, the fabric and VLAN ID numbers must be the

same.

In each FCoE map, the fabric ID, FC-MAP value, and FCoE VLAN parameters must

be unique.

To remove a fabric-VLAN association from an FCoE map, enter the no fabric-id

vlan command.

You must first create a VLAN and then specify the configured VLAN ID in the

fabric-id vlan command. Otherwise, the following error message is displayed.

FTOS(conf-fcoe-f)#fabric-id 10 vlan 10 % Error: Vlan 10 does

not exist

Commands

fcoe-map — creates an FCoE map which contains the parameters used in the

communication between servers and a SAN fabric.

show fcoe-map — displays the Fibre Channel and FCoE configuration parameters

in FCoE maps.

fcf-priority

In an FCoE map, configure the priority used by a server CNA to select an upstream FCoE forwarder (FCF).

Syntax

fcf—priority priority

Parameters

priority Enter the priority assigned to the switch with the FC Flex IO

module NPIV proxy gateway, which appears to a

downstream server CNA as an FCF. The range of FCF

priority values is from 1 to 255.

Defaults 128