CLI Guide

Line Beginning
with
Description
• Interface type and slot/port or object number,
description, and time since the last change in the state of
the tracked object.
• Cost to be subtracted from the VRRP group priority if the
state of the tracked interface/object goes DOWN.
Example
Dell#show vrrp ipv6
------------------
GigabitEthernet 5/6, IPv6 VRID: 255, Version: 3, Net:
fe80::201:e8ff:fe7a:6bb9
State: Master, Priority: 101, Master: fe80::201:e8ff:fe7a:6bb9
(local)
Hold Down: 0 centisec, Preempt: TRUE, AdvInt: 100 centisec
Accept Mode: FALSE, Master AdvInt: 100 centisec
Adv rcvd: 0, Bad pkts rcvd: 0, Adv sent: 64
Virtual MAC address:
00:00:5e:00:02:ff
Virtual IP address:
1::255 fe80::255
vrrp-ipv6-group
Assign an interface to a VRRP group.
Syntax
vrrp-ipv6-group vrid
Parameters
vrid Enter the virtual-router ID number of the VRRP group. The
VRID range is from 1 to 255.
Defaults Not configured.
Command Modes INTERFACE
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
The VRRP group only becomes active and sends VRRP packets when a link-local
virtual IP address is configured. When you delete the virtual address, the VRRP
group stops sending VRRP packets.
• When VRF microcode is not loaded in CAM, the VRID for a VRRP group is the
same as the VRID number configured with the vrrp-group or vrrp-ipv6-
group command.
Virtual Router Redundancy Protocol (VRRP)
1551