CLI Guide

Parameters
vrid (OPTIONAL) Enter the number of an IPv6 VRRP group. The
range is from 1 to 255.
vrf instance (OPTIONAL) Enter the name of a VRF instance (32
characters maximum) to clear the counters of all IPv6 VRRP
groups in the specified VRF.
Defaults Not configured
Command Modes INTERFACE
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
NOTE: This command also enables you to clear the port configurations
corresponding to a range of ports.
You can specify multiple ports as slot/port-range. For example, if you want to
clear the port configurations corresponding to all ports between 1 and 4,
specify the port range as clear counters interfacesinterface-type
1/1 - 4.
debug vrrp ipv6
Allows you to enable debugging of VRRP.
Syntax
debug vrrp ipv6 interface [vrid] {all | packets | state |
timer}
Parameters
interface Enter the following keywords and slot/port or number
information:
For a Port Channel interface, enter the keywords port-
channel then a number.
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
For a VLAN interface, enter the keyword vlan then the
VLAN ID. The VLAN ID range is from 1 to 4094.
vrid (OPTIONAL) Enter a number from 1 to 255 as the VRRP
group ID.
all Enter the keyword all to enable debugging of all VRRP
groups.
1548
Virtual Router Redundancy Protocol (VRRP)