CLI Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
This command applies to a single interface. When used with the vrrp delay
reload CLI, the later timer rules the VRRP enabling. For example, if vrrp delay
reload
is 600 and the vrrp delay minimum is 300:
• When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up
VRRP on all interfaces that are up and configured for VRRP.
• When an interface comes up, whether as part of a system reload or an interface
reload, the system waits 300 seconds (5 minutes) to bring up VRRP on that
interface.
Related Command vrrp delay reload — sets the delay time for VRRP initialization after a system reboot.
vrrp delay reload
Set the delay time for VRRP initialization after a system reboot.
Syntax
vrrp delay reload seconds
Parameters
seconds Enter the number of seconds for the delay. The range is
from 0 to 900 (0 indicates no delay).
Defaults 0
Command Modes INTERFACE
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
This command applies to all the VRRP configured interfaces on a system. When
used with the vrrp delay minimum CLI, the later timer rules the VRRP enabling.
For example, if vrrp delay reload is 600 and the vrrp delay minimum is
300:
• When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up
VRRP on all interfaces that are up and configured for VRRP.
1546
Virtual Router Redundancy Protocol (VRRP)