CLI Guide

Parameters
ip-address1 Enter an IP address of the virtual router in dotted decimal
format. The IP address must be on the same subnet as the
interface’s primary IP address.
... ip-address12 (OPTIONAL) Enter up to 11 additional IP addresses of virtual
routers in dotted decimal format. Separate the IP addresses
with a space. The IP addresses must be on the same subnet
as the interface’s primary IP address.
Defaults Not configured.
Command Modes VRRP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
The VRRP group only becomes active and sends VRRP packets when a virtual IP
address is configured. When you delete the virtual address, the VRRP group stops
sending VRRP packets.
A system message appears after you enter or delete the virtual-address
command.
To guarantee that a VRRP group becomes MASTER, configure the VRRP group’s
virtual address with the same IP address as the interface’s primary IP address and
change the priority of the VRRP group to 255.
You can ping the virtual addresses configured in all VRRP groups.
vrrp delay minimum
Set the delay time for VRRP initialization after an interface comes up.
Syntax
vrrp delay minimum seconds
Parameters
seconds Enter the number of seconds for the delay for VRRP
initialization after an interface becomes operational. The
range is from 0 to 900 (0 indicates no delay).
Defaults 0
Command Modes INTERFACE
Supported Modes Full–Switch
Virtual Router Redundancy Protocol (VRRP)
1545