CLI Guide

vlt-peer-lag port-channel
Associate the port channel to the corresponding port channel in the VLT peer for the VLT connection to
an attached device.
Syntax
vlt-peer-lag port-channel id-number
Parameters
id-number Enter the respective vlt port-channel number of the peer
device.
Defaults Not configured.
Command Modes INTERFACE PORT-CHANNEL
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Supported on the M I/O Aggregator.
show vlt private-vlan
Display the association of private VLAN (PVLAN) with the VLT LAG. You can configure VLT peer nodes in a
PVLAN on the switch.
Syntax
show vlt private-vlan
Command Modes EXEC
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.3(0.0) Introduced on the MXL 10/40GbE Switch IO Module
platform.
Usage Information If you add an ICL or VLTi link as a member of a primary VLAN, the ICL becomes a
part of the primary VLAN and its associated secondary VLANs, similar to the
behavior for normal trunk ports. VLAN symmetricity is not validated if you associate
an ICL to a PVLAN. Similarly, if you dissociate an ICL from a PVLAN, although the
PVLAN symmetrictiy exists, ICL is removed from that PVLAN in such a case. The ICL
Status field denotes the type of the VLAN port of the VLTi link configured in a
PVLAN.
1532
Virtual Link Trunking (VLT)