CLI Guide

system-mac
Reconfigure the default MAC address for the domain.
Syntax
system-mac mac-address
Parameters
mac-address Enter the system MAC address for the VLT domain.
Defaults Not configured.
Command Modes VLT DOMAIN
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Supported on the M I/O Aggregator.
Usage Information
When you create a VLT domain on a switch, Dell Networking OS automatically
creates a VLT-system MAC address used for internal system operations.
To reconfigure the default MAC address for the domain by entering a new MAC
address in the format nn:nn:nn:nn:nn:nn, use the system-mac command.
You must also reconfigure the same MAC address on the VLT peer switch.
unit-id
Explicitly configure the default unit ID of a VLT peer switch.
Syntax
unit-id [0 | 1]
Parameters
0 | 1 Configure the default unit ID of a VLT peer switch. Enter 0
for the first peer or enter 1 for the second peer.
Defaults Automatically assigned based on the MAC address of each VLT peer. The peer with
the lower MAC address is assigned unit 0; the peer with the higher MAC address is
assigned unit 1.
Command Modes VLT DOMAIN
Supported Modes Programmable-Mux (PMUX)
Full–Switch
1530
Virtual Link Trunking (VLT)