CLI Guide

ARP Reg Request rcvd:1
VLT IOA Statistics
-------------------------------
IOA Info Pkts sent: 5
IOA Info Pkts Rcvd: 7
IOA Reg Request sent: 2
IOA Reg Request rcvd: 2
IOA Reg Response sent: 2
IOA Reg Response rcvd: 1
VLT NDP Statistics
--------------------
NDP NA VLT Tunnel Pkts sent:0
NDP NA VLT Tunnel Pkts Rcvd:0
NDP NA Non-VLT Tunnel Pkts sent:0
NDP NA Non-VLT Tunnel Pkts Rcvd:0
Ndp-sync Pkts Sent:0
Ndp-sync Pkts Rcvd:0
Ndp Reg Request sent:2
Ndp Reg Request rcvd:1
VLT multicast not enabled
stack-unit iom-mode
Set the switch operating mode to VLT mode.
Syntax
stack-unit <unit-number> iom-mode vlt
Parameters
unit number
<0-5>
Enter the number of the member stack unit. The range is
from 0 to 5. The default is 0.
vlt Enable virtual link trunking mode.
Command Modes CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Supported on the M I/O Aggregator.
Usage Information This command resets the operating mode to VLT. You must reboot the switch after
using this command.
Virtual Link Trunking (VLT)
1529