CLI Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Added the IPV6/IPV4 support on the MXL.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information When the timer expires, the software checks to see if the VLT peer is now available.
If the VLT peer is not available, peer-routing is disabled on that peer.
primary-priority
Reconfigure the primary role of VLT peer switches.
Syntax
primary-priority value
Parameters
value To configure the primary role on a VLT peer, enter a lower
value than the priority value of the remote peer. The range is
from 1 to 65535.
Default 32768
Command Modes VLT DOMAIN
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information After you configure the VLT domain on each peer switch on both sides of the
interconnect trunk, by default, the software elects a primary and secondary VLT
peer device. To reconfigure the primary role of VLT peer switches, use the
priority command.
show ip mroute
View the multicast routing table.
Syntax
show ip mroute [static | group-address [source-address] | count
| snooping [vlan vlan-id] [group-address [source-address]] |
summary | vlt [group-address | count]
Virtual Link Trunking (VLT)
1521