CLI Guide

ManualsBrandsDell ManualsAccess PlatformsFN IO Module

1501

vlan-stack dot1p-mapping

Map C-Tag dot1p values to an S-Tag dot1p value. You can separate the C-Tag values by commas and

dashed ranges are permitted. Dynamic mode CoS overrides any Layer 2 QoS configuration if there is

conflicts.

Syntax

vlan-stack dot1p-mapping c-tag-dot1p values sp-tag-dot1p value

Parameters

c-tag-dot1p value Enter the keyword c-tag-dot1p then the customer dot1p

value that is mapped to a service provider do1p value. The

range is from 0 to 5.

sp-tag-dot1p

value

Enter the keyword sp-tag-dot1p then the service provider

dot1p value. The range is from 0 to 5.

Defaults none

Command Modes INTERFACE

Supported Modes Full–Switch

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.

vlan-stack protocol-type

Define the stackable VLAN tag protocol identifier (TPID) for the outer VLAN tag (also called the VMAN

tag). If you do not configure this command, the system assigns the value 0x9100.

Syntax

vlan-stack protocol-type number

Parameters

number Enter the hexadecimal number as the stackable VLAN tag.

You may specify both bytes of the 2-byte S-Tag TPID. The

range is from 0 to FFFF. The default is 9100.

Defaults 0x9100

Command Modes CONFIGURATION