CLI Guide

downstream TengigabitEthernet 0/2,4,6,11
upstream TengigabitEthernet 0/8, 12
upstream PortChannel 1
!
uplink state track 2
downstream TengigabitEthernet 0/1,3,5
upstream TengigabitEthernet 0/9,10
Related
Commands
• show uplink-state-group — displays the status information on a specified
uplink-state group or all groups.
• uplink-state-group — creates an uplink-state group and enables the tracking of
upstream links.
show uplink-state-group
Display status information on a specified uplink-state group or all groups.
Syntax
show uplink-state-group [group-id] [detail]
Parameters
group-id Displays status information on a specified uplink-state group
or all groups. The valid group-id values are from 1 to 16.
detail Displays additional status information on the upstream and
downstream interfaces in each group
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
Example
Dell#show uplink-state-group detail
(Up): Interface up (Dwn): Interface down (Dis): Interface
disabled
1500
Uplink Failure Detection (UFD)