CLI Guide

Version Description
9.2(0.0) Supported on the M I/O Aggregator.
Example
Dell(conf-uplink-state-group-16)# description test
Dell(conf-uplink-state-group-16)#
Related
Commands
uplink-state-group — creates an uplink-state group and enables the tracking of
upstream links.
downstream
Assign a port or port-channel to the uplink-state group as a downstream interface.
Syntax
downstream interface
To delete an uplink-state group, enter the no downstream interface
command.
Parameters
interface Enter one of the following interface types:
• 10 Gigabit Ethernet: tengigabitethernet {slot/
port |slot/port-range}
• Port channel: port-channel {1-512 | port-
channel-range}
Where port-range and port-channel-range specify a
range of ports separated by a dash (-) and/or individual
ports/port channels in any order; for example:
tengigabitethernet 1/1-2,5,9,11-12 port-
channel 1-3,5. A comma is required to separate each
port and port-range entry.
Defaults none
Command Modes UPLINK-STATE-GROUP
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
Usage Information
You can assign physical port or port-channel interfaces to an uplink-state group.
1496
Uplink Failure Detection (UFD)