CLI Guide

configure any tunnel allow-remote entries, the tunnel—mode command fails
unless the decapsulate-any option is included
Configuration of IPv6 commands over decapsulate-any tunnel causes an error.
tunnel source
Set a source address for the tunnel.
Syntax
tunnel source {ip-address | ipv6–address | interface-type-
number}
To delete the current tunnel source address, use the no tunnel source
command.
Parameters
ip-address Enter the source IPv4 address in A.B.C.D format.
ipv6–address Enter the source IPv6 address in X:X:X:X::X format.
interface-type-
number
• For a Port Channel interface, enter the keywords port-
channel then a number from 1 to 128.
• For a 10–Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Defaults none
Command Modes INTERFACE TUNNEL (conf-if-tu)
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
If you configure a tunnel interface or destination address, the tunnel source must
be compatible.
If you configure a tunnel source address as an interface, the tunnel does not
function until the compatible address is present on the particular interface.
1474
Tunneling