CLI Guide

8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
ntp offset-threshold
Configure the threshold time interval before which the system generates an NTP audit log message if the
time difference from the NTP server is greater than a threshold value (offset-threshold).
Syntax
ntp offset-threshold threshold-value
To disable the threshold value, use the no ntp offset-threshold command.
Parameters
offset-threshold
threshold-value
(Optional) Enter the keyword offset-threshold and then
the threshold value. The range is from 0 to 999.
Defaults Not enabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S3038–ON, S4048-ON, S3100 Series,
S4810P, S4820T, S5000, S6000, S6000–ON, S6100–ON,
Z9500, and Z9100–ON.
Usage Information
The ntp offset-threshold command does not time synchronization.
Example
Dell(config)# ntp offset-threshold 4
ntp server
Configure an NTP time-serving host.
Syntax
ntp server {ipv4-address}
Parameters
ipv4-address Enter an IPv4 address (A.B.C.D).
Defaults Not configured.
Command Modes CONFIGURATION
Supported Modes All Modes
System Time
1463