CLI Guide

Usage Information Broadcast storm control is valid on Layer 2/Layer 3 interfaces only. Layer 2
broadcast traffic is treated as unknown-unicast traffic.
storm-control broadcast (Interface)
Configure the percentage of broadcast traffic allowed on an interface.
Syntax
storm-control broadcast [packets_per_second in]
To disable broadcast storm control on the interface, use the no storm-control
broadcast [packets_per_second in] command.
Parameters
packets_per_seco
nd
Enter the packets per second of broadcast traffic allowed
into the network. The range is from 0 to 33554368.
Defaults none
Command Modes INTERFACE (conf-if-interface-slot/port)
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
storm-control multicast (Configuration)
Configure the packets per second (pps) of multicast traffic.
Syntax
storm-control multicast packets_per_second in
To disable storm-control for multicast traffic into the network, use the no storm-
control multicast packets_per_second in command.
Parameters
packets_per_seco
nd
Enter the packets per second of multicast traffic allowed
into the network. The range is from 0 to 33554368.
Defaults none
Command Modes CONFIGURATION (conf)
Supported Modes Full–Switch Mode
Command History
Version Description
1444
Storm Control