CLI Guide

To disable storm control, use the no io-aggregator broadcast storm-
control command.
Defaults Enabled
Command Modes
• CONFIGURATION
Supported Modes Standalone-Mux (SMUX)
Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
Usage Information This command is not available in PMUX mode.
show io-aggregator broadcast storm-control status
Shows if storm control is enabled or disabled. If enabled, displays information on the rate limit value.
Syntax
show io-aggregator broadcast storm-control status
Command Modes
• EXEC Privilege
Supported Modes Standalone-Mux (SMUX)
Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Example
Dell#show io-aggregator broadcast storm-control status
Storm-Control Enabled
Broadcast Traffic limited to 1000 Mbps
Dell#
1440
Storm Control