CLI Guide

stack Enable stack mode.
standalone Enable stand-alone mode.
vlt Enable virtual link trunking mode.
full-switch Enable full-switch mode.
Defaults standalone
Command Modes
• CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.6.(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information This command is supported on the M I/O, FN410S, and FN410T Aggregators.
Example
Dell(conf)#stack-unit 0 iom-mode stack
% You are about to stack your IOA module, please reload the IOA
and then plug in the stacking cable for the changes to take
effect.
Dell(conf)#
Dell#
Related
Commands
reload— Reboots the operating system.
show system— displays the current status of all stack members or a specific
member.
stack-unit priority
Configure the ability of a switch to become the management unit of a stack.
Syntax
stack-unit stack-number priority 1-14
Parameters
stack-number Enter the stack member unit identifier.
1–14 This preference parameter allows you to specify the
management priority of one backup switch over another,
with 0 the lowest priority and 14 the highest. The switch
with the highest priority value is chosen to become the
management unit if the active management unit fails or on
the next reload.
1436
Stacking Commands