CLI Guide

Parameters
unit number <0–
5>
Enter the number of the member stack unit. The range is
from 0 to 5.
Defaults none
Command Modes EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.6.(0.0) Supported on the FN I/O Aggregator.
Usage Information This command is supported on the M I/O, FN410S, and FN410T Aggregators.
Example
Dell#show system stack-unit 0 stack-group ?
configured Configured stack groups
| Pipe through a command
<cr>
Dell#show system stack-unit 0 stack-group configured
Configured stack groups in stack-unit 0
Dell#show system stack-unit 0 stack-group
Stack group Ports
------------------------------------
0 0/9
1 0/10
2 0/11
3 0/12
Dell#
Related
Commands
reload— reboots the system.
show system— displays the current status of all stack members or a specific
member.
stack-unit iom-mode
Toggle the operating mode between programmable multiplex, standalone, stack, full–switch,and VLT
modes.
Syntax
stack-unit <unit-number> iom-mode [programmable-mux | stack |
standalone | vlt | full-switch
Parameters
unit number
<0-5>
Enter the number of the member stack unit. The range is
from 0 to 5.
programmable-
mux
Enable programmable multiplex mode.
Stacking Commands
1435