CLI Guide

Usage Information
This command is supported on the M I/O, FN410S, and FN410T Aggregators.
The following describes the show interfaces command shown in the following
example.
Field Description
Topology Lists the topology of stack ports connected: Ring, Daisy
chain, or Standalone.
Interface The unit/port ID of the connected stack port on this unit.
Link Speed Link Speed of the stack port (10) in Gb/s.
Admin Status The only currently listed status is Up.
Connection The stack port ID to which this unit’s stack port is
connected.
Example
Dell# show system stack-ports
Topology: Ring
Interface Connection Link Speed Admin Link Trunk
(Gb/s) Status Status Group
0/9 10 up down
0/10 1/10 10 up up
1/9 10 up down
1/10 0/10 10 up up
Dell#
Example (Status)
Dell# show system stack-ports status
Topology: Daisy chain
Interface Link Speed Admin Link Trunk
(Gb/s) Status Status Group
0/9 10 up down
0/10 10 up up
1/9 10 up down
1/10 10 up up
Example
(Topology)
Dell# show system stack-ports topology
Topology: Daisy chain
Interface Connection Trunk
Group
0/9
0/9 1/10
1/10
1/10 0/10
Dell #
Related
Commands
power-cycle stack-unit—resets the designated stack member.
show diag— displays the data plane or management plane input and output
statistics of the designated component of the designated stack member.
Stacking Commands
1433