CLI Guide

logging on — enables logging.
logging version
Displays syslog messages in a RFC 3164 or RFC 5424 format.
Syntax
logging version {0|1}
Defaults
0
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the FN IOM.
9.5(0.0) Introduced on the MXL.
Usage Information
To display syslog messages in a RFC 3164 or RFC 5424 format, use the log version
command in configuration mode. By default, the system log version is set to 0.
The following describes the two supported log messages formats:
• 0 – Displays syslog messages format as described in RFC 3164, The BSD syslog
Protocol
• 1 – Displays SYSLOG message format as described in RFC 5424, The Syslog
Protocol
Example
Dell(conf)#logging version ?
<0-1> Select syslog version (default = 0)
Dell(conf)#logging version 1
show logging
Display the logging settings and system messages logged to the internal buffer of the switch.
Syntax
show logging [number | history [reverse][number] | reverse
[number] | summary]
1424
Simple Network Management Protocol (SNMP) and Syslog