CLI Guide

Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The oid-tree variable is a full sub-tree starting from 1.3.6 and cannot specify the
name of a sub-tree or a MIB. The following Example configures a view named
rview that allows access to all objects under 1.3.6.1.
Example
Dell#(conf) snmp-server view rview 1.3.6.1 included
Related
Commands
show running-config — displays the SNMP running configuration.
snmp trap link-status
Enable the interface to send SNMP link traps, which indicate whether the interface is up or down.
Syntax
snmp trap link-status
To disable sending link trap messages, use the no snmp trap link-status
command.
Defaults Enabled.
Command Modes INTERFACE
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information If the interface is expected to flap during normal usage, you could disable this
command.
Syslog Commands
The following commands allow you to configure logging functions on all Dell Networking switches.
Simple Network Management Protocol (SNMP) and Syslog
1411