CLI Guide

priv (OPTIONAL) Enter the keyword priv to specify both
authentication and then scrambling of the packet.
community-string Enter a text string (up to 20 characters long) as the name of
the SNMP community.
NOTE: For version 1 and version 2c security models, this
string represents the name of the SNMP community.
The string can be set using this command; however,
Dell Networking OS recommends setting the
community string using the snmp-server community
command before executing this command. For version
3 security model, this string is the USM user security
name.
udp-port port-
number
(OPTIONAL) Enter the keywords udp-port then the port
number of the remote host to use. The range is from 0 to
65535. The default is 162.
notification-type (OPTIONAL) Enter one of the following keywords for the
type of trap to send to the host:
• ecfm — Notification of ECFM state changes.
• entity — Notification of entity changes.
• envmon — Environment monitor trap.
• eoam — Notificaiton of EOAM state changes.
• ets — Notification of ets trap changes.
• fips — Notification of FIP snooping state changes.
• lacp — Notificaiton of LACP state changes.
• snmp — SNMP notification (RFC 1157).
• stp — Spanning tree protocol notification (RFC 1493).
• vrrp — State change in a VRRP group.
• xstp — State change in MSTP (802.1s), RSTP (802.1w),
and PVST+.
The default is all trap types are sent to host.
Defaults As above.
Command Modes CONFIGURATION
Supported Modes Full–Switch Mode
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Simple Network Management Protocol (SNMP) and Syslog
1403